/*==============================================================
 File........Alaonix smart 256x160 LCD display module
             Load images Test code for Arduino
 Purpose.....This test code for Alaonix smart 256x160 LCD display module
 Board.......Arduino nano
 Software....Arduino 1.8.13
 MCU.........Arduino ATmage328p
 Auther......Alaonix Team
 Website.....WWW.Alaonix.com
 Email.......AlaTeam@Alaonix.com
 Started.....
 Updated.....
 Note: MINIMUM CONNECTION:
       5V  <==========> Ala LCD 5V 
       GND <==========> Ala LCD GND
       Arduino Tx <===> Ala LCD Rx 
=================== Parameter =============================*/
void setup() {
  Serial.begin(19200);        // start serial port at 19200 bps
  delay(1000);
  while (!Serial) {
  // wait for serial port to connect. Needed for native USB port only
  }
}
void loop() {
     Serial.println("mr");                  // Change to root direction
     
     delay(50);
     Serial.println("mj,alaimage");         // Change to image direction
     
     delay(50);
     Serial.println("ML,0,0,0,0,image_1");  // Load image 1
     
     delay(1000);
     Serial.println("ML,0,0,0,0,image_2");  // Load image 2
     
     delay(1000);
     Serial.println("ac,1,0");
     
     delay(50);
     Serial.println("ML,70,0,0,0,image_3");  // Load image 3
     
     delay(1000);
     Serial.println("ac,1,0");
     
     delay(50);
     Serial.println("ML,70,0,0,0,image_4");  // Load image 4
     
     delay(1000);
     Serial.println("ac,1,0");
     
     delay(50);
     Serial.println("ML,70,0,0,0,image_5");  // Load image 5
     
     delay(1000);
     Serial.println("ML,0,0,0,0,image_6");  // Load image 6
     
     delay(1000);
     Serial.println("ML,0,0,0,0,image_7");  // Load image 7
     
     delay(1000);
     Serial.println("ac,0,0");  
     
     delay(50);
     Serial.println("fa,12,35,30,2,1,0,Thank you for watch!");  
     
     delay(50);
     Serial.println("Gb,20,236,62,2,1,0");  
     
     delay(50);
     Serial.println("fA,25,25,65,0,1,0,Alaonix");  
     
     delay(50);
     exit(0);
}